Melted Ignition module and ccci fuse blowing

GNTTYPE Discussion Group: Electrical, Sensors, and Gauges: Melted Ignition module and ccci fuse blowing
Top of pagePrevious messageNext messageBottom of pageLink to this message  

frank marshall (Turbofrank)

Monday, August 05, 2002 - 09:54 am Click here to edit this post
Went to check a friends car after the installation
of a coil pack. friend said the ccci fuse kept blowing. After removing the coilpack which was glued to the module the module was fried. Also anytime you touched the batt. hot wire
sparks would go everywhere After the coil/module was removed the sparking stopped. Did the check to test fusible link from the blower motor power was there.What could cause this damage ?

Top of pagePrevious messageNext messageBottom of pageLink to this message  

frank marshall (Turbofrank)

Monday, August 19, 2002 - 06:00 pm Click here to edit this post
Found out the module was definitely bad. I guess
the circuit in this case remained open blowing the fuse and sparking the battery cable.


Add a Message


This is a private posting area. A valid username and password combination is required to post messages to this discussion.
Username:  
Password: