C.A.R.B. parts

GNTTYPE Discussion Group: Induction, Injection, Alcohol, and Exhaust: C.A.R.B. parts
Top of pagePrevious messageNext messageBottom of pageLink to this message  

Dale Schonauer (Dale)

Wednesday, August 21, 2002 - 10:28 am Click here to edit this post
I recently moved to California and of course most of the mods I have made (specifically the aftermarket Kenne Bell air cleaner kit, breather by-pass and turbo inlet bell) are not legal. Unfortunately, with all the moves I have made in the military the old parts are gone. Any recommendations for C.A.R.B. parts or a source for original replacemants?

Top of pagePrevious messageNext messageBottom of pageLink to this message  

frank marshall (Turbofrank)

Thursday, August 22, 2002 - 05:22 am Click here to edit this post
Most military people keep there home state lic and tags can't you still do that.

Top of pagePrevious messageNext messageBottom of pageLink to this message  

Dale Schonauer (Dale)

Friday, August 23, 2002 - 08:09 am Click here to edit this post
No, I was registered in Hawaii. I cannot renew when the reg runs out unless I get a new safety inspection from Hawaii. Not likely. I need to put it stock, at least for a while.

Top of pagePrevious messageNext messageBottom of pageLink to this message  

frank marshall (Turbofrank)

Friday, August 23, 2002 - 01:33 pm Click here to edit this post
Check the turbo trader for parts you should find
everything you need or contact these 2 people they deal in selling used parts.
BWEAVY@aol.com
mrturboregal@peoplepc.com
They are on the eastcoast.

Top of pagePrevious messageNext messageBottom of pageLink to this message  

Phil Aubrey (Paubrey)

Friday, August 23, 2002 - 06:03 pm Click here to edit this post
It's hard to find a knowledgeable somg tech when it comes to these cars. The air cleaner is not heated or restricted and should not be considered when doing a smog check. Same goes for turbo bell. The breather is another story. The other unique thing is the cats get lazy with miles and if not real hot will cause a C/O fail at idle. Trick is raise minimum air rate so idle is around 900 rpms and make sure cat is hot.


Add a Message


This is a private posting area. A valid username and password combination is required to post messages to this discussion.
Username:  
Password: