Ed Sobulefsky (Ejs488) | Saturday, July 19, 2003 - 06:27 am Im running an 85 gn motor in my 63 olds and have a problem with the boost.Im running a turbo 350 trans. Here are the things that Ive checked. Checked to make sure I had the restrictor tee in right. If I pull the line off the accuator from the compressor side the turbo and pulled the line off at the solenoid turbo will go to 14lbs. I pulled the waste gate solenoid off and put 12v to it and will open and passes air. I checked for power on the solenoid and have 12v on both sides with key on no run, If I pull the connector off the solenoid I have 12v just on one side. I have to change my speedo gear because im about 20mph slow Also does it matter if I just leave the line disconnected? Is there a way to check if the ecm is grrounding the wire? Does anyone have a diagram or know which wire it would be at the ecm? I could try and run a new wire between the ecm and solenoid. |