Cam Installation
GNTTYPE Discussion Group
:
Engine Mechanicals
: Cam Installation
Carl Olson (86grandnasty)
Tuesday, March 12, 2002 - 10:07 pm
I was wondering if it is possible to replace the cam and cam bearings without removing the engine from the car.
Thanks,
Carl
Ken Mosher (Kenmosher)
Wednesday, March 13, 2002 - 09:13 am
Yes, but when you get it torn down that far, it's worth the extra 15-20 minutes to just pull it completely out.
Easier to work on then breaking your back bending over the fenders!
Add a Message
This is a private posting area. A valid username and password combination is required to post messages to this discussion.
Username:
Password: