PAUL R CUMMINGS (Prcturbo) | Tuesday, November 20, 2001 - 08:05 am Those using these, do they position the push rods more centered in the hole than the stock rockers? Someone once mentioned this but since they use the same P/N for both banks I did not see how this was possible. Can anyone confirm this for me as I plan to use them in my rebuild. Any comments please. Thanks paul |
PAUL R CUMMINGS (Prcturbo) | Wednesday, November 21, 2001 - 08:01 pm Ok, so I picked up these rocker arm assemblies. Now my question is the hold down holes are larger than the stock shaft holes, will this create any problems? I'm concerned about the slop there could be in the positioning while using the stock bolts? Why also is there new pedestal supports, arn't these GN specific (RA-1068)? THANKS PAUL |
PAUL R CUMMINGS (Prcturbo) | Sunday, November 25, 2001 - 05:36 am Where is everyone on this board? Can someone who has used these please help with your response. Need to know if these are going to be weaker with the larger holes (.062"). Wrong shafts maybe or that is the way they all are? Do the stoker shafts wear out or is it just the rocker arms that wear? Thanks for all the help, if you respond. |
Ken Mosher (Kenmosher) | Sunday, November 25, 2001 - 08:26 am There have been responses on the email list to this ... basically, they're fine. The bolts will center and everything will line up/hold correctly. |
PAUL R CUMMINGS (Prcturbo) | Sunday, November 25, 2001 - 01:18 pm thanks ken for closing this for me. |