I will be replacing my manifold seals and valley pan, among other things, this weekend on my car... Should I use a sealant, such as Hylomar, on the intake gaskets, specifically: the manifold cooler gasket, intake seals, front and rear manifold gaskets, and throttle housing gasket?
As always, your advice and suggestions are much appreciated.
________________________
"Too much is never enough"
93 Formula Mods: 383, LE2 Heads/Intake, 226/230 cam, 52MM TB, Magnaflow cat back, LT headers, Gasket Sealers, CAI, SFC, Strut Brace, Adj LCA, Adj Panhard, Relocated Torque Arm, Progressive Rate Springs, Short Throw Shifter