View Single Post
  #10  
Old 01-02-2009, 07:04 AM
jakeshoe jakeshoe is offline
The Trans Guy
 
Join Date: Aug 2007
Location: Texas
Posts: 25
jakeshoe is on a distinguished road
Default Re: 200-4R Rebuild ... step by step!

Remove the direct drum and forward drum if not already out, remove and discard the 2nd gear band, remove the output shaft retaining snap ring.



You can then remove the selective washer and thrust washer, front internal ring gear, front planetary, and front sun gear.


Now slide the sun shell and shaft out.



Remove the low carrier snap ring. And then remove the low clutch housing. This usually requires a special tool but can be done using a couple of "L" shaped devices to get behind it and work forward.


Once this is accomplished you can remove the spacer snap ring fromt he case and pull the output shaft forward to remove the output ring gear, rear planetary assembly, and all the low reverse clutches.

Last edited by jakeshoe; 03-19-2009 at 03:54 AM.
Reply With Quote