View Single Post
  #19  
Old 03-19-2009, 04:17 AM
jakeshoe jakeshoe is offline
The Trans Guy
 
Join Date: Aug 2007
Location: Texas
Posts: 25
jakeshoe is on a distinguished road
Default Re: 200-4R Rebuild ... step by step!


Check endplay with a feeler gauge between the snap ring and selective washer. .005-.010" is ideal here. Take the time to get it right.

You are now ready to disassemble the rear section and install it in the case.

Disassemble it to the rear planetary. Set the output shaft, rear ring gear, and rear carrier assembly in the case. Position the output shaft using the tool or other means so that the ring gear lugs line up with the parking pawl.



Reply With Quote