Thread
:
200-4R Rebuild ... step by step!
View Single Post
#
20
03-19-2009, 04:19 AM
jakeshoe
The Trans Guy
Join Date: Aug 2007
Location: Texas
Posts: 25
Re: 200-4R Rebuild ... step by step!
Now begin to install the low/reverse clutch pack, begin with a steel plate. Then a friction, and alternate until you end with a steel plate. There should be 6 frictions and 7 flat steels. Once you install the last steel, install the cushion plate.
Now install the case to support snap ring. It is a very thin flimsy ring.
jakeshoe
View Public Profile
Send a private message to jakeshoe
Visit jakeshoe's homepage!
Find all posts by jakeshoe