[PaCemkr86]

Now, to begin connecting the MAP to the Power Logger Analog Input Block1) Locate the the light green wire in the wiring bundle. It is the signal wire coming from the MAP and going to the LED boost gauge. Tee a wire into it. If you look at the picture and see the black tape, then you will see the red wire I soldered to the green wire. If you have some quality wire taps, you could use them to make the Tee connection rather than soldering. Note that the green wire does not need to be cut, and, the LED gauge will still work...particularly if you use the rebuilt boost gauge and tach from Caspers.