Thread: Body day 1
View Single Post
  #3  
Old 02-06-2010, 07:27 PM
larrym's Avatar
larrym larrym is offline
Senior Contributor
 
Join Date: Jun 2007
Location: BC
Posts: 271
larrym is on a distinguished road
Default progress

Well its been fun so far, welders flash when welding hurts like a bastard.
Got the drip rail in the trunk fixed, the rest looked pretty good.
Got my first coat of primer on my new door hung, fixed the dent in the hood that was a PITA to get the body line to my liking.
Going to fog on a guide coat, sand and see how straight it is.
Then its time to seal it and top coat

the top was not as bad as I thought by the time I had it cleaned up all I had to do was por 15 and fill the 1 hole in the center, the worst was the black centre section picked one up off evilbay for $ 50.00 including freight .

http://photoshare.shaw.ca/messages/v...iew/page/1/15/

http://photoshare.shaw.ca/messages/v...arm/page/1/15/
__________________
60lb injectors
Gen 2 with Extender Chip
Webber 212/206 roller cam
Turbonetics BB CPT 61
CAS V4 Stretch Intercooler
Alcohol Injection
4 inch MAF pipe with integral sensor
2800 stall
lots of fun with a little 6 banger!
Best ET 11.43
Reply With Quote