View Single Post
  #16  
Old 03-19-2009, 04:06 AM
jakeshoe jakeshoe is offline
The Trans Guy
 
Join Date: Aug 2007
Location: Texas
Posts: 25
jakeshoe is on a distinguished road
Default Re: 200-4R Rebuild ... step by step!

Install a torrington bearing in the front side of the rear carrier. There is usually a plastic thrust washer here. Do not use it, replace it with the torrington bearing as GM did on the later model 200-4Rs.



Install the low roller clutch (sprag) and then the inner race by turning. The race should have the splined side up.




Install the carrier into the rear ring gear:



Now you can install the low support onto the rear carrier.
Reply With Quote