View Single Post
  #6  
Old 03-30-2014, 05:03 AM
JAMIEPACURN JAMIEPACURN is offline
Senior Contributor
 
Join Date: Apr 2012
Location: INDIANA
Posts: 250
JAMIEPACURN is on a distinguished road
Default Re: Scanmaster hook up

If I remember correctly I think there was three wires to the Scan Master. One wire goes to ground, one wire goes to a power source or ignition source, and the other wire goes to the orange wire (ECM wire) Its been awhile but wasn't to bad to install. Just make sure you use a good ground source!!!!

Click on my screen name "JAMIEPACURN" and there are pictures of my 1987 T-Type so that you can see 1 option where to mount the scan master. I tried to upload a single picture on here but this site wouldn't allow me to re-post the same picture. Hope this helps you out but you can use your imagination and put it where it best suits your taste.


Jamie C.
Reply With Quote