Re: cruise stalk
Here are the pics of cruise removal.
pic 1 removal which is twist to the left and pull, stalk will pop out.
pic 2 you will need to remove both lower fuse panel and column panel.
pic 3 cut old stalk from wire and to tape to new wire pull through gently, not shown is a plastic electrical cover remove this prior otherwise it will likely catch or snag on it.
pic 4 wire end location close to the center console.
pic 5 insert stalk and twist to the right and violla you're done!
__________________
87 gn stock turbo, adj. waste gate act, hot wired 340 warlboro pmp, accufab reg., 42lb inj., 2 fan set-up, kenne bell cold air, smc alky kit, 2800 l/up converter, tt chip, scanmaster, not track tested heck not out of my garage shes gettin a makeover.
Last edited by onefastcar; 01-20-2006 at 09:24 PM.
|