View Single Post
  #6  
Old 08-07-2007, 12:19 PM
ryan87gn ryan87gn is offline
Senior Member
 
Join Date: Jan 2007
Location: OH
Posts: 173
ryan87gn is on a distinguished road
Default Re: an excellent write up how to read boost w/ powerlogger

Quote:
Originally Posted by PaCemkr86
Now, to begin connecting the MAP to the Power Logger Analog Input Block1) Locate the the light green wire in the wiring bundle. It is the signal wire coming from the MAP and going to the LED boost gauge. Tee a wire into it. If you look at the picture and see the black tape, then you will see the red wire I soldered to the green wire. If you have some quality wire taps, you could use them to make the Tee connection rather than soldering. Note that the green wire does not need to be cut, and, the LED gauge will still work...particularly if you use the rebuilt boost gauge and tach from Caspers.
Thanks, yes I got that piece. I spliced a red wire into the light green wire. What does the other end attach to? All I see is Analog Input Block. Is this an obvious place on the powerlogger that I connect to?
__________________
87 GN, GT3255E, SMC Alcohol Injection, Mototron 60# Injectors, XP Fuel Pump, Fuel Enhancer, Kenne Bell Ram Air, 3" DP, LS-1 MAF, 3 1/2" MAF Pipe, TurboTweak Chip
Reply With Quote