This is a general site search and does not include list archives. | |||||||
|
|
#1
|
|||
|
|||
Scanmaster hook up
I got a scanmaster for my '87 but no instructions. Can anyone help?
|
#2
|
||||
|
||||
Re: Scanmaster hook up
__________________
Scott Keller - GNTTYPE Founder & Moderator
|
#3
|
|||
|
|||
Re: Scanmaster hook up
hello; On the hook up I know the scanmaster has been out for a while but where is your favorite wire connection locations?
IBBY |
#4
|
||||
|
||||
Re: Scanmaster hook up
Data pretty much has to come from the ALDL port or its wires. Power can be any ignition switched source, such as those in the fuse box. If you don't already have a fuse in line, you can add a small one with a connector from Radio Shack or somewhere similar.
__________________
Scott Keller - GNTTYPE Founder & Moderator
|
#5
|
|||
|
|||
Re: Scanmaster hook up
How about mounting options for the Scan Master? I have it on the bottom right side of the IP cluster surround right now, but the sight line isn't that great. Other options?
|
#6
|
|||
|
|||
Re: Scanmaster hook up
If I remember correctly I think there was three wires to the Scan Master. One wire goes to ground, one wire goes to a power source or ignition source, and the other wire goes to the orange wire (ECM wire) Its been awhile but wasn't to bad to install. Just make sure you use a good ground source!!!!
Click on my screen name "JAMIEPACURN" and there are pictures of my 1987 T-Type so that you can see 1 option where to mount the scan master. I tried to upload a single picture on here but this site wouldn't allow me to re-post the same picture. Hope this helps you out but you can use your imagination and put it where it best suits your taste. Jamie C. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|