GN and T-Type Performance Enthusiasts (GNTTYPE) Forums GN and T-Type Performance Enthusiasts (GNTTYPE) Forums
This is a general site search and does not include list archives.

Go Back   GN and T-Type Performance Enthusiasts (GNTTYPE) Forums > Technical Topics > Transmission / Torque Converter Tech

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #21  
Old 03-19-2009, 04:22 AM
jakeshoe jakeshoe is offline
The Trans Guy
 
Join Date: Aug 2007
Location: Texas
Posts: 25
jakeshoe is on a distinguished road
Default Re: 200-4R Rebuild ... step by step!

Now the low support can be installed. There is a feed hole and wide spline. This faces the valve body or bottom side of the case. This is best accomplished using a support installer/remover tool as shown but can be done by other means.





Now the beveled snap ring needs to be installed to hold the low support housing in place.
Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 08:49 PM.


This page maintained by: gnttype-webmaster@gnttype.org

The content, images, text and multimedia displayed and contributed by the members of the Grand National and T-Type Performance Enthusiasts Organization are Copyright ©1996-2005. No part, section, image, article or whole of this site may be reposted or redisplayed without permission of the author/contributor and/or the Grand National and T-Type Performance Enthusiasts Organization.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.