This is a general site search and does not include list archives. | |||||||
|
#1
|
||||
|
||||
O2 Sensor Thread size......
...ok. I know the size is M18x1.5 pitch, but i cant find a Tap anywhere without buying a $125 kit [ and my tap and die kit only goes to M12 ] i have tried a couple of auto parts places one had a 14mm tap [doesnt do me any good] but then i found a 14mm/18mm sparkplug chaser. 1. are O2 sensors the same pitch as sparkplugs and 2. Is a chaser strong eneough to tap? Thanx for any future replys.
|
#2
|
||||
|
||||
Re: O2 Sensor Thread size......
i have one if you cant fine one.. I'll ship it you if you wanna borrow it
|
#3
|
||||
|
||||
Re: O2 Sensor Thread size......
thanx Phil, i will try here locally and if things dont pan out i will take you up on your offer.
|
#4
|
|||
|
|||
Re: O2 Sensor Thread size......
Can't you go get a bung from a muffler shop? Or consider getting a nut with that pitch/thread and welding it to the pipe?
__________________
Just another not stock regal. P&P heads/intake, 61mm GT, SLIC w/neck, SMC boozamahol, Sewer sized DP, 60#inj, TT 93, Hofer tranny, fuel cell, A1000 pump, stock cam/pistons, 100lb springs, titanium retainers, SS polished TA valves. |
#5
|
|||
|
|||
Re: O2 Sensor Thread size......
I said bung
__________________
Just another not stock regal. P&P heads/intake, 61mm GT, SLIC w/neck, SMC boozamahol, Sewer sized DP, 60#inj, TT 93, Hofer tranny, fuel cell, A1000 pump, stock cam/pistons, 100lb springs, titanium retainers, SS polished TA valves. |
#6
|
||||
|
||||
Re: O2 Sensor Thread size......
Quote:
but goin back to the original question? Phil, [or someone else] Is the m18 spark plug chaser the same pitch as my o2 sensor? |
#7
|
||||
|
||||
Re: O2 Sensor Thread size......
i got mine off the snap-on truck.. it was 18-20 bucks
**ill check on the thread size |
#8
|
||||
|
||||
Re: O2 Sensor Thread size......
How bad did you munge it? If you folded threads over, a chaser won't work. If they're just a little damaged, a chaser might to it. Just be sure to keep the chaser/threads lubed while spinning it. Do you have a proper tap handle?
__________________
Scott Keller - GNTTYPE Founder & Moderator
|
#9
|
||||
|
||||
Re: O2 Sensor Thread size......
http://cgi.ebay.com/ebaymotors/Lot-o...spagenameZWDVW
< ----you can get 2 of em here for 10 bucks Cleans Threads in Oxygen Sensor Holes. Use with 3/4" hex socket or 3/8" square drive. Size: M18x1.5 Also works on M18x1.5 spark plug threads. Last edited by PaCemkr86; 07-06-2007 at 01:19 PM. |
#10
|
||||
|
||||
Re: O2 Sensor Thread size......
thanx for the link Phil and the offer. I took care of it.
-aaron |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|