an excellent write up how to read boost w/ powerlogger
|
Re: an excellent write up how to read boost w/ powerlogger
Scott can you make this a **sticky
|
Re: an excellent write up how to read boost w/ powerlogger
Done. Great info!
|
Re: an excellent write up how to read boost w/ powerlogger
What about the red wire that was attached to the light green wire? What does that attach to? Thanks.
|
Re: an excellent write up how to read boost w/ powerlogger
Now, to begin connecting the MAP to the Power Logger Analog Input Block1) Locate the the light green wire in the wiring bundle. It is the signal wire coming from the MAP and going to the LED boost gauge. Tee a wire into it. If you look at the picture and see the black tape, then you will see the red wire I soldered to the green wire. If you have some quality wire taps, you could use them to make the Tee connection rather than soldering. Note that the green wire does not need to be cut, and, the LED gauge will still work...particularly if you use the rebuilt boost gauge and tach from Caspers.
|
Re: an excellent write up how to read boost w/ powerlogger
Quote:
|
Re: an excellent write up how to read boost w/ powerlogger
Yes, it is.
|
Re: an excellent write up how to read boost w/ powerlogger
Quote:
|
Re: an excellent write up how to read boost w/ powerlogger
If it weren't 98 freaking degrees with 97% humidity outside I would be doing this RIGHT NOW but instead I'm hiding inside trying to stay cool, my god it's HOT out there :(
Very good write up, I'm printing it out now and will probably do this asap (as soon as I won't die of heat stroke trying to do it haha). |
Re: an excellent write up how to read boost w/ powerlogger
|
All times are GMT -4. The time now is 02:13 AM. |
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.